![]() ![]() If you ssh with the new user to your diskstation and run it you would be asked to enter your password before the command is executed. To shutdown the diskstation we use the command sudo poweroff. Make sure to give the user adminstrator rights otherwise he cannot execute the poweroff command.Control Panel -> User -> Create -> Enter password, username.Create HomeAssistant User on diskstationįirst we need to create a new user on our diskstation:Ĭreate a user which can be used from home assistant to login to your diskstation To turn off the diskstation remotely we need to login via ssh and call the poweroff command. For more details see the integration documentation. The host parameter contains the ip of the diskstation, so it can check if the diskstation is online or not. My configuration looks like this: switch: We just need to supply the mac address of our diskstation in the configuration. It allows to add a switch which sends the packages when it is turned on. This can be done with the Wake on LAN integration. Now we need to send this magic package from Home Assistant. Your device is identified by the mac address. This is NOT the ip-address of your device, this is the broadcast address. Note: For sending a magic package via wakeonlan you can specify an ip: -i ip_addressĭefault: 255.255.255.255 (the limited broadcast address) # Wake up diskstation by using its MAC Address on a Mac you could run following command in the terminal: # Install wakeonlan command via brew Under Power Recovery activate Enable WOL on LanĪfter that you are able to start your Diskstation over the network.Go to Control Panel > Hardware & Power > General.Diskstation configurationįirst we need to enable Wake on Lan on our diskstation: We can use Wake on Lan to turn of the diskstation by a network message. This article describes the configuration steps, necessary for this. I achieved this by controlling the Diskstation via Home Assistant. Also it would be nice if I could turn it off with my "good night"-Switch next to my bed. Another example would be to power on the diskstation to store a Home Assistant Backup and afterwards power it off again. I would like to automatically turn on the Diskstation when I come home, so my Smartphone can backup data. It would turn on at a certain time and power off every night. In the past I configured a "Power schedule" directly within the Diskstation. Therefore it does not need to run all the time. I still can’t fully figure it out, truthfully.I use my Synology Diskstation mainly as a backup device. I recently had some issues with the reverse mac address solution. Otherwise, the switch will assume the state depending on the switches last action. To enable the switch to check the status of the device, set its IP address again in the host field. After it, we put the reverse magic packet in the mac field, as well as the IP address of the device under broadcast_address. Under the turn_off section, we set our service: wake_on_lan.send_magic_packet. You can find all of this information on the page generated by the SOL installation as well as the reverse mac address for the sleep functionality. After you’ve installed SOL on your target machine, and you’re familiar with Home Assistants Wake On LAN functionality, create a new entry in your configuration.yaml: wake_on_lan:įill out the top half of the wake_on_lan switch as usual, giving it the name you prefer, the IP address of the device under broadcast_address and the magic packet in the mac field. To begin, confirm your computer has WOL enabled- either in the BIOS or by adjusting your network adapter settings. Once integrated properly, you can fully put a computer to sleep, wake it, and monitor its status. Using Sleep-On-Lan allows you to very easily expand upon Home Assistant’s built in Wake-On-Lan functionality. Home Assistant Automation Networking Introduction ![]()
0 Comments
Leave a Reply. |